Welcome, Guest
Please Login or Register.    Lost Password?

MR2 Parts required
(1 viewing) (1) Guest
Go to bottomPage: 1
TOPIC: MR2 Parts required
#80013
MR2 Parts required 6 Years, 7 Months ago Karma: 1
Hi I'm looking for a set of the copper heater pipes that Run down the centre of the tunnel. The fuel tank sits under them. Does anyone have a set available please .image enclosed. Thanks
Vegantune
Fresh Boarder
Posts: 16
graphgraph
User Offline Click here to see the profile of this user
Comments? Suggestions? Register above to have your say!
 
#80015
Re: MR2 Parts required 6 Years, 7 Months ago Karma: 72
Dont bother with them pipes take them out and throw them away, if you decide to buy secondhand ones its only a matter of time before they leak too.
Here is a permanent fix for you, take the long stainless steel pipes running under the fuel tank and cut a hole in them just where the fuel tank ends and weld on 2 smaller pipes which you can fit hoses to, extend them hoses up through that hole in front of fuel tank and into the heater rad in the frunk.

_KUNENA_BBCODE_HIDEIMG

_KUNENA_BBCODE_HIDEIMG
spla300
Booooost!!!
Expert Boarder
Posts: 1364
graphgraph
User Offline Click here to see the profile of this user
Gender: Male Location: longford
Comments? Suggestions? Register above to have your say!
 
#80019
Re: MR2 Parts required 6 Years, 7 Months ago Karma: 1
Thanks thats a good idea. Although I might opt for the hydraulic grade flexible pipe conversion marketed by mrben. Many thanks for your reply
Vegantune
Fresh Boarder
Posts: 16
graphgraph
User Offline Click here to see the profile of this user
Comments? Suggestions? Register above to have your say!
 
Go to topPage: 1