@ martyj - Yip i am using grade 80 sand paper as i have alot to fill due to the previous owner damaging the kit
if your using filler start with grade 80,120,finish with 320 and then prime the piece and rub down with wet 2000 and 4000 doing an install i used wood for the buld head then cut out the shape of the speakers and then used expandable foam as this is easy to cut with a hacksaw blade into what shape you want. I ran 1 inch pipe from the back of the speakers through the car and into the engine bay as to help the speakers breathe if not you will blow them eventually then i fiberglassed over the wood and then used 50 yo yo's of filler for the back bulk hard its a bit of work but when done right pays off
@ infamous - Yip i choose white as its the only colour for a lambo
Here is a picture with the doors on 6 months back
_KUNENA_BBCODE_HIDEIMG
Uploaded with
ImageShack.us
Here is a picture at the drivers rear wheel arch you can see the breather pipe for the sub behind the driver
_KUNENA_BBCODE_HIDEIMG
Uploaded with
ImageShack.us
Here is the wing mirrors they lads in the UK use the MR2 mirror motors to make them fold in but i decided not to use them as if they burn out it will be an expensive fit so i moulded the mirrors into one piece ;)
This was done 8 months ago i will just show you the work involved
The mirrors when i got it in two pieces
_KUNENA_BBCODE_HIDEIMG
After a week of rubbing i got to here
_KUNENA_BBCODE_HIDEIMG
Uploaded with
ImageShack.us
And the mirrors painted in black these have been sent off for carbon fiber dipping the same as the dash
_KUNENA_BBCODE_HIDEIMG
Uploaded with
ImageShack.us
Here was the nightmare of the build moving the fuel pipe the hardship i had and my hands were in bits this is a pipe i made and the angle had to be right
_KUNENA_BBCODE_HIDEIMG
Uploaded with
ImageShack.us
here we go
