coils arrived today, and couldn't resist test wiring them in and setting up the AEM.

They worked like a dream straight away - yeoooo

Few pics of the test install


_KUNENA_BBCODE_HIDEIMG


_KUNENA_BBCODE_HIDEIMG


_KUNENA_BBCODE_HIDEIMG

Now I can put a massive gap on the plugs with no chance of stuttering!!

Have to make a bracket to hold them in now, and tidy the wiring.

Looks awesome Mark! very nice

Just verified the timing there with a light.

Idle is so much better now. Have the plugs gapped away back up at 0.030''

Once I get a bracket made up tomorrow I can test her out at 2 bar.

did a bit of tidying up. This will do until I finish making the bracket that will clip on to the strut brace. The cut up bit of silicon coupler is to stop annoying vibrating. I'll be sandwiching a slimmer version in with the new bracket.

Have gapped the plugs to 0.040'' - running like a charm. I've seen videos of these particular coils producing a good spark with a 1cm gap!

I have to relocate the damned catch can now - probably under the left hand side engine inspection panel. plenty of room down there by the air filter.


_KUNENA_BBCODE_HIDEIMG


_KUNENA_BBCODE_HIDEIMG


_KUNENA_BBCODE_HIDEIMG

Awesome Mark! wow your engine bay is getting complicated. Where's your bov?

Impressive work

Are you going to drop down for the Christmas run on the 6th December ? Would love to see this in action !!

Quandry wrote:
Awesome Mark! wow your engine bay is getting complicated. Where's your bov?

I've welded the BOV to the aluminium pipe coming from the turbo - you can just see the side of it there in one of the engine bay pics.