|
rev 4 turbo into rev 3 na 8 Years, 6 Months ago
|
Karma: 2
|
|
lads and lassies, have a rev 4 turbo engine now fitted into my rev 3 na, had complete rev 4 doner car but i just swapped loom to footwell out and obviously engine loom. car wont start and wont run the fuel pump.. any ideas off hand or will i just get buried into the wiring diagrams? thought this was plug and play? cheers in advance
|
|
|
|
|
|
|
Re: rev 4 turbo into rev 3 na 8 Years, 6 Months ago
|
Karma: 2
|
|
cranks but no fuel
|
|
|
|
|
|
|
Re: rev 4 turbo into rev 3 na 8 Years, 6 Months ago
|
Karma: 328
|
|
Check if you are getting voltage to the fuel pump when cranking.
|
|
|
|
"Happier than a tornado in a trailer park"
"Just as in cuisine, the ‘flavor’ of a car is quite important…”
Hiromu Naruse 1943-2010 RIP |
|
|
Re: rev 4 turbo into rev 3 na 8 Years, 6 Months ago
|
Karma: 29
|
|
Did you use your rev 4 fuel pump or the na one?
|
|
st182r
JOR MR2 PARTS
Senior Boarder
Posts: 578
|
|
|
|
|
Re: rev 4 turbo into rev 3 na 8 Years, 6 Months ago
|
Karma: 72
|
|
If you used all the turbo wiring, looms etc. from the donor car it should work no problem, check all fuses in frunk, driver footwell and engine bay. and go over all the clips again make sure everything is connected.
if your fuel pump dosent work you can try pour a cap full of petrol into the intake and see if she starts for a second, if she starts at least you know everything else is ok.
you are close good luck.
|
|
|
|
|
|
|
